Find your perfect fit

Our rings are made in whole and half U.S. sizes 4–11. If you already own a ring that fits the intended finger, measure its inside diameter and find the closest match below.

How to measure your finger

1. Cut a thin strip of paper (about 10cm long and 5mm wide) or use a piece of non-stretchy string.
2. Wrap it snugly around the base of your finger — it should slide over your knuckle with a little resistance.
3. Mark where the paper overlaps, then lay it flat and measure the length in millimeters.
4. Match that measurement to the circumference column. Between sizes? Choose the larger.

Tip: measure at the end of the day when your fingers are warm, and measure three or four times for accuracy. Wide bands (4mm+) fit more snugly, so go up a half size.

Wrap a soft tape measure around your wrist just above the wrist bone, then add 0.5–1 in (1.3–2.5 cm) for a comfortable fit. Most of our chain bracelets are adjustable with a 1 in extender.

Cuffs and bangles are one size and gently adjustable — open and close them slowly from the sides, never by twisting.

Measured end to end including the clasp. Most chains include a 2 in extender so you can adjust to your neckline.

Print this page at 100% scale (turn off “fit to page”) and check a measurement against a ruler before you rely on it. Still unsure? Order two sizes and return the one that doesn't fit — non-engraved rings qualify for our 60-day returns.